Monobloc Load Cell Type SA (10,000kg)


Calibrated weighing of lorry payloads (on-board weighing systems)


  • Specially adapted for the application
  • Calibration capability
  • Insensitive to side-loads thanks to guide-plate construction
  • Built-in pendulum bearing with lift-off protection
  • Built-in calibration memory
  • Robust, industrial execution (IP 68)
  • High overload capability

Measuring principle

As in all DIGI SENS products, an oscillating-wire sensor is used to convert force into an electrical signal. This patented element is able to generate directly a digital output signal, which brings big advantages in accuracy, immunity to interference and electronic signal processing

Mechanical construction

Type SA load cells consist of a guide plate of high-tensile steel and the KS oscillating-wire transducer.

Thanks to the guide plate, torsion forces due to eccentrically applied loads are filtered out and complicated bearing pad constructions, designed to prevent stresses, become superfluous. This is particularly important in lorries with a flexible chassis and often a stiff superstructure.

Signal processing

The data specific to the load cell are recorded in a built-in memory. No adjustment whatsoever is necessary after commissioning or when a load cell is replaced.

A 5V TTL output signal is available. The DIGI SENS ELEIRO computer is to be recommended as a control unit and for signal processing. It is designed for up to eight load cells and can combine the measured values from the different cells in real time. The signals from the four SA load cells are added, then divided by the two signals from the BJ inclination cells, in order to compensate the tilt.

For more details read our data sheet: S007E_04.pdf

This website uses cookies to improve the user-friendliness. With the usage of our webseite you permit us to use cookies.